wiring grain of wheat bulbs
Posted
#184092
(In Topic #10359)
Guest user
Bulbs in semaphore signals
Help required. I am building some white metal square post semaphore signals for my 0 gauge layout but now have a few questions. 1. if all wires are soldered to the signal as suggested, how do your change bulb if it blows 2. what is the smallest 2 pin plug anyone has found - thought I might be able to hide this within the gantry 3. is it possible to connect a 1.5v bulb to my accessory 5v supply without putting 4 in series
Posted
Site staff
Help required. I am building some white metal square post semaphore signals for my 0 gauge layout but now have a few questions. 1. if all wires are soldered to the signal as suggested, how do your change bulb if it blows With difficulty but if you run the bulb at a lesser voltage than the rated voltage, the problem is greatly reduced.
2. what is the smallest 2 pin plug anyone has found - thought I might be able to hide this within the gantry
3. is it possible to connect a 1.5v bulb to my accessory 5v supply without putting 4 in series only by installing a resistor in series with the bulb - the resistor value can only be determined by measuring the current with a multimeter in series with a 1.5v torch cell
Ron
NCE DCC ; 00 scale UK outline.
NCE DCC ; 00 scale UK outline.
1 guest and 0 members have just viewed this.