Peco Code 75 three way asymmetric points
Posted
#258303
(In Topic #14109)
Full Member
Utilising as part of a station throat
Hi All. At long last, I would like to add a station, BLT , to my layout, that began as Inglenook junction. I have a Peco three way asymmetric point that was proving a problem to wire, which leaves me the need to purchase of two motors with to keep it simple, rather than WIT which is my preference. Question being, can I squeeze a two carriage train platform and a run round loop onto a four foot long plank utilising the three way asymmetric point, and of course another point at the end of the loop. Oh and how do I control the route. Best wishes Kevin
Staying on the thread Kevin.
Posted
Full Member
Less for a DMU, needing no run round, so just three feet, including the point.
There's nothing better than setting it out on your baseboard however, using a tape measure and chaulk.
I'd stick to WIT for the point control though, as you know how to do it and it works for you.
Bill
At 6'4'', Bill is a tall chap, then again, when horizontal he is rather long and people often used to trip over him! . . . and so a nickname was born :)
Posted
Full Member
Staying on the thread Kevin.
Posted
Full Member
At 6'4'', Bill is a tall chap, then again, when horizontal he is rather long and people often used to trip over him! . . . and so a nickname was born :)
1 guest and 0 members have just viewed this.