have you ot one

Hello,
I think i asked this question a few years ago. Just starting to use mine again after it has sat on the top of the wardrobe for 2 years.

Hello,
I am going to need a sharp slender knife to clean up some of the corners i asume a swan and morton but which blade would be the best, as there are many different types.
Thanks in advance
GreenBR

I'm still using my Zing Air, bought in 2013,  cuts card and plasticard, for thicker card it requires more than 1 pass which can be set from the software, said software is a doddle to use.

Dorsetmike said

I'm still using my Zing Air, bought in 2013,  cuts card and plasticard, for thicker card it requires more than 1 pass which can be set from the software, said software is a doddle to use.

From “Post #287,818”, 25th May 2023, 12:51 PM

Hello,
What is the software called that you use?
Regards
GreenBR

Hello,
I must admit that the bigest gripe with the cricit is that it will not cut PDFs produced on A4 size paper. This means that you need to be able to take the PDf apart as the Cricut cut and print is no were near A 4 in size. As no one apears to be using one on this site i can not get any futher insight into how other people are geting around this problem.
Regards
GreenBR

GreenBR said

Hello,
What is the software called that you use?
Regards
GreenBR

From “Post #287,824”, 26th May 2023, 10:31 AM

It's called Make the cut.
https://make-the-cut.software.informer.com/4.6