#1 in a series of daft Questions

Well here is the first in a line of completely dumb and complicated questions by me :)

I use DCC (NCE Powercab) for controlling the locos on the layout. 

I use a Gaugemaster Q controller, the old fashioned, DC 12v supply with BUS wires to power the points (and signal/lights eventually). I do have a Y point and a double slip switch. What I'd like in simple (idiot terms) how to wire the Seep PM1 point motors so that I can have a LED on the control panel to indicate what route is set for. I'm using Electrofrog code 100 points as well. 

I have seen this post in regards to DCC but I'm not looking to DCC the points yet (maybe eventually).

Thanks in advance 

Neil, no doubt there are many posts with YMRC about your requirements but this site is possible one of the best
http://brian-lambert.co.uk/Electrical%20page%202.html#Mimic

Thanks Sol.