Station set on the North Norfolk coast.

So there is... sorted.

Change of signals!




 

[nitpick] Shouldn't the DMU tail lights be red?[/nitpick]:roll::lol:

They are, looks  like the front lights due to sunlight!!

Cheers
Ron

Couldn't tell you, I'm only getting sound. But the lights sound good to me

Cheers

Toto

Nice clickerty clack over the points Ron :thumbs



Ed

Well done a bit today but 2 problems reared up!
1. My Zimo sound Class 08 just stopped and caused a layout short and still is!!
2. After wiring up a Seep point motor to the DCC system, I found the motor doesn't work even directly of AC!!

Got a couple of trees made and started my timetables!

Probably did less than Tom today!!

Cheers
Ron

Got a new chair though!!

That'll be a first Ron. You are normally in overdrive.

Hope you get these issues sorted out. Where did you pick up the 08 ?

Cheers

Toto

Digitrains in Lincoln, one of Paul Chetter's.. I was in there yesterday and said how well it was running!! (Fatal mistake!!)

Will return iy when I can to see what's wrong!

Sounds as is you had a good day?

Cheers
Ron

I'm sure that Paul will get you sorted out. It's a shame because the 08's sound great and expensive as well.

I've had a great day thanks. Finally got to where I needed to be. It's now time for the points to get sorted out and a bit track cleaning and loco programming. The points will be a tester but will be the icing on the cake to enable me to access all area's of the layout.

Keep us up to date with how the shunter works out.

Cheers

Toto

Will do!
Glad you've had a productive day and feeling better!
Ordering a sweatshirt tomorrow for Warley, think it might be a bit cool for a T shirt!

Cheers
Ron

Been busy Hotel building tonight! Luckily the Superquick Hotel has a double roof so it was easy to just build the front half as a low relief building!

Original..



My version, but is it better on the RHS wall or against the back wall??









Decisions, decisions!! Of course it is not fully finished and there are other bits'n'pieces needed to complete the scene.

Comments welcomed?

Cheers
Ron

Looks good Ron. I thought you were going to put it on the diagonal across the corner.

Toto

I thought you were going to cut it to fit into the corner at an angle.

Back wall for me, Ron.

Enjoyed the vid.  :thumbs

I knew everybody would say that!! I am not that good a modeller and when I got the card model it was so obvious that I could manage to cut it in half without too much difficulty!! (It's my age you know!!)

Cheers
Ron

I don't think you give yourself enough credit. I think you would have breezed it. Leave the lean too bit off and cut each end at 45 degrees job done.

However, you know what you are comfortable with and it still looks good anyway Ron. Iooking forward to what you are going to do around about it.

Cheers

Toto

Yep, back wall for me too Ron. Looks fine.

Marty

Sorry guys, 2 photo's Back or Right just to check?
I can't decide!


or



Sorry to be a PITA but want to get it right!!
Thanks
Ron

I was just looking at the first lot of pictures when you posted Ron.

First picture looking up the embankment somehow looks 'right' to me, so B.

Space is tight though, maybe take the extension off the side to reduce the width of the building to give a bit more room around it?


Ed